A pane that is a few millimetres out is a pane that will not sit right, so we cut everything to the exact size you give us. We have been cutting and supplying glass from our Penge shop for over 30 years, and Beckenham is five minutes down the road. Bring us your measurements, your old pane or a rough sketch. We will tell you what you need and what it costs.
Measure the full opening, not just the glass you can see
Tell us the thickness, or bring an old piece in so we can match it
Say where the glass is going, as doors and low panes need safety glass by law
Keep broken glass taped and flat if you are bringing it to the shop
Most of the glass we supply is cut in house, which is why we can turn so much of it around quickly. We keep clear float, patterned and mirror stock on the shelf, and we order toughened and laminated to size when a job calls for it. If you are not sure which type you need, describe where the glass is going and we will work it out with you.
We work to within a couple of millimetres and build in a small tolerance so the glass beds into the frame properly rather than binding against it.
Any glass in a door, beside a door or below 800mm from floor level counts as a critical location under Building Regulations and must be safety glass.
Clear float, patterned and mirror cuts are usually ready the same or next day. Toughened and laminated are made to order and take a few working days.
Yes. We cut circles, arches and angled pieces, and we drill holes and cut outs for sockets, hinges and handles before the glass is toughened.
We do. Our fitters work across Beckenham and the surrounding area, so we can measure, cut and install the glass for you rather than leaving it at the counter.